The Rover Lanyard
Step-By-Step
After several requests for a step-by-step on building this lanyard, here is how I go about it.
Materials
Center Cord: 30"
Outer Cord: 8'
Large Swivels: 4
Loop your 30" cord and knot/burn ends. Anchor over a standing peg. This is your center cord, it is tied in different color for demonstration purposes. the center cord will remain straight and will not roll or twist.
Add your 8ft outer cord to the peg ( I use 8 ft because I would rather have more than fall short and it's easier to work with on knots).
Make an overhand loop as shown, around your center cords. This will form your belt/tippet loops. You want the overhand to be 5" from the peg.
Begin your Solomon knot, maintaining the 5" and even loops.
After your second Solomon knot cinch all down tight, maintaining the measurements for the loops. Once tight, you can remove the peg and all will stay in place.
Continue Solomon knots, keeping center cord straight.
Complete 20 Solomon knots, which should put you right near 4" in length with 5" loops.
Make an overhand knot on either side to anchor your Solomon portion. Tie them with the running-end facing up.
Slide on a swivel on either side
Make another overhand knot in the same manner 2" up on either side. Slide the 2nd set of swivels on.
Tie a Bowline knot on each side capturing both an outside loop and center loop with each.
Cut and burn each end to secure.
You Rover lanyard is complete.
The working end of the center cord is left long to make attaching a tippet container, fly box or whatever you choose possible.
The top loops slide up through the tippet spools and you can either loop your belt through them or add a snaplink.
https://www.ironlist.com/category/used-agriculture-tractors-for-sale?indId=902&catId=8020
ReplyDeleteAn absolute URL: Used tractors for sale
Delete